Advertisement
Available languages
Available languages
Air Filter - Inspection
and
Replacement
Hot surfaces.
Risk
of burn.
Compressor
heads are exposed
when filter cover is removed.
Allow compressor to cool prior to
servicing.
A dirty air filter will not allow the
compressor to operate at full
capacity.
Keep the air filter clean at
all times.
1.
Remove the air filter cover.
2.
Remove the air filter from filter
cover.
IMPORTANT:
Do not operate the
compressor
with the air filter
removed.
3.
Place new air filter into filter
cover. Refer to the "Repair Parts"
for the correct part number.
4.
Replace air filter cover and lock
into place.
Belt - Replacement
(Refer to the Outfit Parts Manual
for replacement
belt part number.)
Serious injury or
damage may occur
if parts of the body or loose items
get caught in moving parts. Never
operate the outfit with the belt
guard removed. The belt guard
should be removed only when the
AIR compressor power is
disconnected.
1.
Turn air compressor
off, lock out
the power supply, and relieve all
air pressure from the air tank.
2.
Remove the belt guard.
3.
Mark pump position on saddle.
4.
Loosen the motor mounting
screws and slide the motor
toward the air compressor.
5.
Remove the belt and replace
with a new one.
6.
See the "Adjust Belt Tension"
before tightening motor
mounting screws.
Adjusting
Belt Tension
1.
Slide motor into original position,
line the motor up with the mark
made earlier on saddle.
2.
Tighten two outside motor
mounting screws enough to hold
the motor in place for checking
pulley and flywheel alignment.
3.
The belt should deflect 3/16" at
midway between the pulley and
the flywheel when a 5 pound
weight is applied at the midway
point.
4.
When proper belt tension is
achieved, tighten all four motor
mounting screws. See Parts
manual for torque specifications.
NOTE: Once the engine pulley has
been moved from its factory
set
location, the grooves of the
flywheel and pulley must be aligned
to within 1/16" to prevent excessive
belt wear. Verify the alignment by
performing the following Pulley and
Flywheel - Alignment.
19-ENG
D26625
Advertisement
