Oki LE810DT Setup Manual page 5

8. Raise the Outside Media Guide to the closed position and
push the guide inward until it barely contacts the outside
edge of the media.
9. If your printer does not have an internal
rewinder, then skip to step 14.
10. Remove 24" to 30" of labels from the backing paper
to provide enough backing paper free of labels to
wrap around the Backing Take-Up Spindle.
10
11. Route the label backing down the front of the print
mechanism and around the Backing Drive Roller.
11
12. Wrap the backing under and around the Backing
Take-Up Spindle, routing it under the two Backing
Retainer Prongs.
12
13. Manually turn the Backing Take-Up Spindle counter-
clockwise to take up all the slack in the backing.
Note: Inspect the media routing and verify
that the path matches that illustrated in the
Media Loading diagram on the inside of the
Top Access Door.
13
14. Close the Print Head and latch it in the down position.
14
15. Close the Front Access Door. After the Front Access
Door is closed, the Top Access Door may be closed.
These covers have interlock switches and the printer
will not operate if either is open.
15
5
b