Troubleshooting - Escort Passport 9500CI Owner's Manual

Radar and laser defence system
Hide thumbs Also See for Passport 9500CI:
Table of Contents

Advertisement

Troubleshooting

Problem
Solution
PASSPORT beeps briefly at the
• An X or K-band motion sensor or intrusion alarm is
same location every day, but no
located within range of your route. You can manually
radar source is in sight.
lock this out using TrueLock, or allow AutoLearn to
do it over time.
PASSPORT does not seem
• PASSPORT may be in Auto or AutoNox mode.
sensitive to radar or laser.
PASSPORT did not alert when a
• VASCAR, (Visual Average Speed Computer And
police car was in view.
Recorder) a stopwatch method of speed detection,
may be in use.
PASSPORT only beeped twice
• This is normal. Full alerts are minimized when
during a radar encounter.
traveling below 25 mph.
PASSPORT's audible alerts are
• PASSPORT is in AutoMute Mode. See page 4 for
less loud after the first few
details.
alerts.
PASSPORT's power-on
• A loose power connection can cause PASSPORT to
sequence reoccurs while you
be briefly disconnected, and will retrigger the power-
are driving.
on sequence.
Your 14-year old son has
• You can return all of the Preferences to their factory
changed all of your Preferences.
defaults by holding down the SENS and VOL buttons
while you turn PASSPORT on.
PASSPORT will not turn on.
• Check that the PWR button is ON.
• Check that vehicle ignition is ON.
• Check all connections.
26
Explanation of Displays
Lsr R
There is a problem with the rear laser receiver (it could be an
N/A
unplugged connection, damaged wiring, or a problem within the rear
laser unit itself).
Check
There is a problem with the front receiver (it could be an unplugged
Receiver
connection, damaged wiring, or a problem within the front receiver
Wiring
itself). PASSPORT will continue to display this message, and will not
operate until the problem has been repaired.
ANX
Sensitivity control is in Auto No X-band. (page 7)
H
Sensitivity control is in Highway mode. (page 14)
PilotHWY
One of the many options in Preferences (pages 12-16)
WorkZone
One of the many Safety Radar messages (pages 24-25)
Caution
PASSPORT has detected a Safety Radar Signal, but the signal isn't yet
strong enough to decode the specific safety message (pages 24-25)
X |
PASSPORT has been programmed in the ExpertMeter Mode (page 11)
K |
or
KA |
or
etc.
Receiver
PASSPORT has failed to calibrate. Contact your Dealer for repair.
Error
GPS N/A
Not able to receiver GPS signal. Check GPS antenna connection.
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents