Powering Down The Disk Array - HP StorageWorks XP10000 - Disk Array Owner's Manual

Hp storageworks xp10000 disk array owner's guide (ae102-96013, march 2008)
Hide thumbs Also See for StorageWorks XP10000 - Disk Array:
Table of Contents

Advertisement

CAUTION:
Do not perform any procedures not described in this guide. If you have any questions or concerns,
contact your HP support representative.
WARNING!
Do not touch areas marked HAZARDOUS, even with the power off. These areas contain
high-voltage power.
CAUTION:
If you detect any abnormal noise, smell, or smoke coming from the disk array, immediately power
off the disk array by following the emergency power off procedure later in this chapter. For routine
power off in non-emergency situations, contact your HP support representative.
CAUTION:
Do not power off the system unless it is an emergency situation and you follow the procedure for
Emergency power off.
CAUTION:
Keep the front and rear doors closed at all times.
CAUTION:
Keep the tops and sides of the cabinets clear to allow air to flow properly.
CAUTION:
Use the supplied power cord. The power cord may not be used with other products.

Powering down the disk array

Two situations may arise when you need to power down the system:
Emergency power off
Planned power off
For instructions in each of these situations, see the following procedures.
28
HP XP10000 operations

Advertisement

Table of Contents
loading

Table of Contents