Lan Access Control (Network Authentication) - Ericsson IP Vision Dialog 4425 User Manual

Log on
Log on
BusinessPhone – Ericsson Dialog 4425 IP Vision

LAN access control (network authentication)

(Dialog 4425 v. 2 phone only).
Your telephone might require a network authentication to gain
access to the network. In this case you must enter a valid user
identity and password.
Note: The user identity and password used for the network
authentication is not the same user identity and password
you use to log on. The password is obtained from, and can
only be changed by the system administrator.
Settings
User administrator mode to change IP settings
z
Enter your user identity.
(The display menu key
z
Press (see display).
Enter your password.
(The display menu key
Note: The password can be entered with letters or
numbers, see section
Press (see display).
If your user identity and password are accepted, the phone
continues with the startup procedure.
Note: If your user identity and password are not accepted,
contact your system administrator.
CallList Contacts
Erase
, is used to remove a wrong entry.)
Erase
, is used to remove a wrong entry.)
"Write
Start the Phone – Log On/Off
?
(No change)
Text" on page 90.
(x)
21