Changing The Light Bulbs; Removing The Base Grille - Whirlpool ET20NK Use And Care Manual

Changing the light bulbs
Electrical Shock Hazard
Before removing a light bulb, either
unplug the refrigerator or disconnect the
electricity leading to the refrigerator at
the main power supply.
Failure to do so could result in electriial
shock or personal injury.
To change the refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Panel to remove
bulb.
3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE:
Not all commercial appliance bulbs will
fit your refrigerator. Be sure to replace a bulb
with one of the same size and shape.
Removing the base grille
To remove the grille:
1.
Open refrigerator door.
2. Pull base grille forward to release the
support tabs from the metal clips.
3.
Do not remove Tech Sheet
fastened
behind the grille.
To replace the grille:
1.
Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 16.
Condenser coils
13