Panasonic Lumix DMC-FX700 Operating Instructions Manual page 85

Others
• The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format (P31) the card in this unit.
If you want to delete some pictures, format the card after saving necessary data on a PC
etc. (P31)
Insert a different card.
• A folder cannot be created because there are no remaining folder numbers that can be used.
(P173)
Format the card after saving necessary data on a PC etc. (P31) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P29)
• The AV cable is connected to the camera.
Press [MENU] if you want to delete this message at once.
Select [TVASPECT] in the [SETUP] menu if you want to change the TV aspect. (P30)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P171,
174)
• The printer cannot print.
Check the printer.
• The remaining battery power is low.
Charge the battery.
• The battery cannot be recognized by the camera.
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
• The battery cannot be recognized as its terminal is dirty.
Remove any dirt etc. from the terminal.
- 7£7 -