Panasonic Lumix DMC-FX700 Operating Instructions Manual page 84

Others
• This message will be displayed when you format the built-in memory on a PC.
Format the built-in memory on the camera again. (P31) The data on the built-in memory
will be deleted.
• It is a format that cannot be used with this unit.
Format the card again with the camera after saving necessary data on a PC etc. (P31)
• This message appears when the camera is not operating properly.
Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
Use a card compatible with this unit. (P19)
• SD Memory Card (8 MB to 2 GB)
• SDHC Memory Card (4 GB to 32 GB)
• SDXC Memory Card (48 GB, 64 GB)
• An error has occurred accessing the card.
Insert the card again.
Insert a different card.
• It has failed to read or write data.
Remove the card after turning the power [OFF]. insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
Insert a different card.
• Use a card with SD Speed Class "Class 4" or higher when recording motion pictures in
[AVCHD].
Also, use a card with SD Speed Class with "Class 6" or higher when recording motion pictures
in [MOTION JPEG].
i_ SD Speed Class is the speed standard regarding continuous writing.
• In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P31).
• Depending on the type of the card, motion picture recording may stop in the middle.
- 190-