Recall Button; R-Tune (Rapid Tune) Button; Mute Button; Multi Button - Panasonic CT-27SF13U Operating Instructions Manual

Control Operation
(cont.)
Helpful Hints:
Recall Button
- Press the RECALL button to
review:
(_ Audio Mode Status
(_ CH Number or Video Input Selected
(_ Sleep Timer Status
(_ Clock Time
(_ Channel Caption (Station Identifier)
SAP CH 03
MONO XYYZ
1_ 29 1:00
® @
®
R-Tune Button
- Pressing the R-TUNE (RAPID
TUNE) button will switch between the last two channels
selected on the numeric keypad.
NOTE: When rapidly scanning channels with the
CHANNEL UP/DOWN button, pressing the
R-TUNE button will switch between the last
channel scanned, and initialchannel at the start
of scanning. _
CHANNEL NOW CHANNEL TUNED
BEING VIEWED IMMEDIATELY BEFORE
Press Button
Press Button Again
.=
Mute Button
- Press the MUTE button to quickly
reduce sound level (Mute will appear on screen). Press
again to restore sound.
Multi Button
The MULTI button can be programmed to operate up
to six (6) Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On and Cable
box Power/On (selected brands) can be operated at the
same time with one press of the MULTI button.
Procedure
1. First program the Remote for the selected device
Infrared access code. Confirm that the Remote
Control is compatible with the equipment.
2. Face the Remote Control transmitter away from all
equipment remote sensors.
3. Press and hold the Remote POWER button, then
press and hold the ACTION button down at the same
time for three seconds. (All previous commands are
erased.) ,_..,_
PRESS AT THE SAME TIME ---_r_-
FOR THREE SECONDS _ J,
4. After three seconds, release the POWER and
ACTION buttons.
5. Press the MULTI button. (Waiting more than 30
seconds without pressing another button will exit the
programming mode.)
6. Press a maximum of six (6) function buttons on the
Remote.
Each button you press is equal to one function. If six
Remote button functions are entered, all will register
in the MULTI button memory in the sequence
entered. When finished, press the MULTI button to
end the program mode.
The following is an example flow chart of Remote
functions that can be programmed into the MULTI
button (The VCR Mode button should be
programmed before starting procedure see pg.40).
PRESS AT THE SAME TIME PRESS PRESS
FOR THREE SECONDS
PRESS PRESS PRESS TO END
PROGRAM MODE
Now you can turn the TV and VCR ON/OFF at the
same time with one press of the MULTI button.
To delete entered functions - Press and hold the
Remote POWER button then press and hold the
ACTION button down at the same time for three
seconds. Now you can enter from one to six different
Remote functions.
NOTE: You can also program the MULTI button to
perform most individual Remote Control button
functions. Buttons which continuously perform
a function as long as pressed (Volume
Up/Down, Channel Up/Down, etc.) cannot be
programmed. Only those buttons which
perform a function when initially pressed
(Power On/Off, Mute, Direct Channel Entry,
etc.) can be programmed.
-15-