Table of Contents
Advertisement
l'V/Video
Button
- Press the TV/VIDEO button
to select desired input.
TVNIDEO
Signal connected to:
REAR VIDEO/AUDIO
INPUT 2 JACKS _'_
REAR VIDEO/AUDIO
_._
INPUT 1 JACKS
TV or CABLE
[
VIDEO 2 I
'D O'l I
CH 02 _J
Recall Button
-
Press the RECALL button to
review:
• Audio Mode status
• CH number or Video Input selected
• Sleep Timer status
• Clock time
• Channel Caption (Station Identifier)
RECALL
SAP
CH 03
MONO
XYYZ
29
1:00
R-Tune (Rapid Tune) Button - Press the
R-TUNE
(RAPID
TUNE)
button to instantly switch
between the last two channels selected (without aqy On
Screen display being activated).
R-TUNE
I
l
CHANNEL
NOW
BEING VIEWED
Press Button
Press Button Again
i
CHANNEL
TUNED
IMMEDIATELY
BEFORE
-9-
Multi
Button
The MULTI button can be programmed to operate up
to 6 Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On (selected
brands) can be operated atthe same time with one press
of the MULT! button.
Procedure
1.
First program the Remote for the selected VCR
Infra-red access code. Confirm that the Remote
Control is compatible with the equipment.
2.
Face the Remote Control transmitter away from all
equipment remote sensors.
3.
Press the Remote TV POWER button and the
MULTI
button
simultaneously.
(All
previous
commands are erased.)
._-rv)
POWER
MULTI
PRESS SIMULTANEOUSLY
4.
Press a maximum of 6 Function buttons on the
Remote.
Each button you press is equal to one function. If six
remote button functions are entered, all will register
in the MULTI button memory
in the sequence
entered. When less than six remote button functions
are entered, press the MULTI button to end the
program mode. (Waiting more than 30 seconds
without pressing another button will also end the
program mode.)
The following is an example of Remote functions
that can be programmed into the MULTI button.
-
TV Power-
For turning TV ON and OFF.
-
VCR Power - For turning
VCR ON and OFF
(selected brands after programming
it's Infra-red
access code, if necessary).
Both can be turned ON or OFF with one press of the
MULTI button.
(TV)
POWER
VCR
POWER
MULTI
To delete entered functions - Press the Remote
TV POWER and MULTI buttons simultaneously.
Now you can enter from one to six different Remote
functions.
(TV)
POWER
MULTI
PRESS SIMULTANEOUSLY
NOTE:
You can also program the MULTI button to perform
most individual Remote Control button functions.
Buttons which continuously
perform a function as
long as pressed
(Volume
Up/Down,
Channel
Up/Down, etc.) cannot be programmed. Only those
buttons which perform a function
when initially
pressed (Power On/Off, Mute, Direct Channel Entry,
etc.) can be programmed.
Advertisement
Table of Contents
