Parts Supplied For Installation - KitchenAid KSSS36DBW00 Installation Instructions Manual

Parts supplied for installation:
l
top grille assembly
. base grille
. tube assembly
l
miscellaneous parts bag
l
ice-maker bin assembly
Check that all parts were included.
Product/Property Damage
l
Do Not lower the refrigerator
against the shipping base when
removing the shipping base.
l
Do Not remove protective film
until refrigerator is in operating
position.
l
All four leveling legs must
contact the floor to support and
stabilize the full weight of the
refrigerator.
l
Keep cardboard shipping piece
or plywood under refrigerator
until it is installed in operating
position.
Failure to follow these instructions
may cause damage to product or
floor covering.
1
. Remove and save top grille
c assembly package, literature package
and parts bag taped to retrlgerator
door. Remove four brackets (two on
each side) attaching shipping base
to refrigerator bottom. Do Not
remove tape and door bracing until
product is secured in final location.
See Page 3.
strap and
u ,
refrigerator at side trim pieces and
handles. Carefully tighten strap
making sure side trim and handles are
protected
Personal Injury Hazard
l
Because of the weight and size of
the refrigerator, two or more
people are required to install it.
l
Most of the refrigerator's weight
is at the top. Extra care is needed
when moving the refrigerator to
prevent tipping.
Failure to follow these instructions
could result in personal injury.
3 3
. Move refrigerator . Move refrigerator
close to built-in opening. close to built-in opening.
Set power switch at top of cabinet
to "OFF" position. Plug power supply
cord into grounded outlet. Install
retainer on grounded outlet using
screw from parts bag.
4
. Place top of cardboard carton or
plywood under refrigerator. Remove
dolly. Open appliance doors and
rernove all boxes, parts packages and
packing materials from refrigerator
and freezer compartments. Do Not
remove protective film.
If side panel(s) will be used, attach
three, square spacers to top, middle
and bottom of the side of refrigerator
that will be adjacent to side panel.
See Page 6
Move the refrigerator straight back
and evenly into the opening. Check
that:
l
copper tubing is not kinked.
l
power supply cord hangs freely
behind refrigerator or is on top of
refrigerator next to cover.
cop
er
P line rom
plumbing
copper
line to
valve
Check that water supply line has
been flushed. See Page 7.
5 . Pull tubing assembly forward.
Slide a compression nut and sleeve on
open end of tubing assembly fitting.
Then connect compression nut and
sleeve on tubing assembly to copper
tubing union. Connect tubing
assembly fitting to water line with
union. Do Not overtighten.
Turn water supply valve to "OPEN"
position. Turn refrigerator switch
"ON." Wait a few minutes. Check
water line connection and water valve
on top of cabinet for leaks. Without
kinking the tubing, carefully place it
back underneath cabinet
6\- s$c~c;~d
. Remove taDe from rear
leveling rods. Turn rear leveling
rods clockwise with a 5/l 6"
(8 mm) socket and ratchet
until cabinet weight is
supported by rear legs. Lower
front leveling legs with channel
lock pliers until weight of the
cabinet is supported by legs.
Note: All four leveling legs
must contact the floor to
support and stabilize the full
weight of the refrigerator. Do
Not use rollers to support the
refrigerator.
Page 8