Craftsman 137.212890 Operator's Manual page 3

L
[_k, WARNING I
Before using your chop saw, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury or damage to the power tool,
Good safety practices are a combination of common
sense, staying alert and understanding how to use your
power tool. To avoid mistakes that could cause serious
injury, do not plug in your power tool until you have read
and understood the following safety rules:
1. READ and become familiar with the entire Operator's
Manual. LEARN the tool's application, limitations and
possible hazards.
2" [_.WARNING I
Look for this symbol that identities important
safety precautions. It means CAUTION!
BECOME ALERT! YOUR SAFETY IS INVOLVED!
15. NEVER LEAVE TOOL RUNNING UNATTENDED.
• TURN THE POWER "OFF". Do not leave the tool
before it comes to a complete stop.
16. NEVER STAND ON TOOL. Serious injury could
occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
17. DO NOT OVERREACH. Keep proper footing and
balance at all times.
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp
and clean for most efficient and safest performance.
Follow instructions for lubricating and changing
accessories.
.
.
.
.
.
.
.
10.
11.
DO NOT USE IN DANGEROUS ENVIRONMENTS
such as damp or wet locations or exposure to rain.
Keep work area well lighted.
DO NOT use power tools in the presence of
flammable liquids or gases.
KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
KEEP CHILDREN AWAY. All visitors should be kept
at a safe distance from the work area.
DO NOT FORCE THE TOOL. It will do the job better
and safer at the rate for which it was designed•
USE THE RIGHT TOOL. Don't force the tool or
attachment to do a job for which it is not designed.
WEAR PROPER APPAREL. DO NOT wear loose
clothing, gloves, neckties, rings, bracelets or other
jewelry that may get caught in moving parts. Non-
slip footwear is recommended. Wear protective hair
covering to contain long hair.
WEAR A FACE MASK OR DUST MASK. Sawing,
cutting and sanding operations produce dust.
DISCONNECT TOOLS before servicing and when
changing accessories such as blades, cutters, etc.
19.
20.
21.
22.
CHECK FOR DAMAGED OR LOOSE PARTS.
Before further use of the tool, a guard or other
part that is damaged should be carefully checked
to ensure it will operate properly and perform its
intended function. Check for alignment of moving
parts, binding of moving parts, loose mounting
and any other conditions that may affect its safe
operation. A guard or other part that is loose or
damaged should be properly adjusted repaired or
replaced.
MAKE WORKSHOP CHILD PROOF with padlocks,
master switches or by removing starter keys.
DO NOT operate the tool if you are under the
influence of any drugs, alcohol or medication that
could impair your ability to use the tool safely.
ALWAYS WEAR EYE PROTECTION. Any power
tool can throw foreign objects into your eyes that
could cause permanent eye damage. ALWAYS
wear safety goggles (not glasses) that comply with
ANSI safety standard Z87.1. Everyday glasses have
only impact resistant lenses. They ARE NOT safety
asses.
OTE: Glasses or goggles not in compliance with
ANSI Z87.1 could cause serious injury when they
break.
12.
13.
REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure the switch is in the OFF
position before plugging into the power supply.
USE ONLY RECOMMENDED ACCESSORIES.
Consult the Operator's Manual for recommended
accessories. The use of improper accessories may
cause injury to you or damage to the tool.
14. REMOVE ADJUSTING KEYS AND WRENCHES.
Form the habit of checking to see that keys and
adjustingwrenches are removed from the tool before
turning ON.