Advertisement
Available languages
Available languages
2.
Position the workpiece between the vise clamp and
the adjustable fence. Turn the handle (1) clockwise
to clamp the workpiece securely.
3. The vise incorporates a quick release locking lever
(4). To use the quick release vise feature, lift up on
the quick release locking lever (4) and slide in or out
the vise to the desired position.
4.
When the desired location for the vise clamp is
achieved, flip the quick release locking lever (4)
forward to engage the threads with the threads of
the vise. Begin to turn the lever (1) clockwise to
secure the workpiece within the vise.
Fig. F
ADJUSTING FOR ANGLE CUTTING (Fig. G )
1. Loosen the vise handle and back away the vise.
2.
Loosen the two bolts (1) of the adjustable fence with
a 17 mm wrench.
3.
Adjust the adjustable fence (2) to the desired angle.
4.
Tighten the two bolts (1).
5. The vise clamp (3) will align itself automatically with
the angle of the workpiece when clamping a
workpiece in position.
Fig. G
1
INSTALLING AND ADJUSTING THE EXTENSION
BRACKET AND STOP BLOCK (FIG. H, H-l):
1. Loosen the locking screw (1) with the 5ram hex
wrench provided (Fig. H).
2.
Insert the extension bracket (2) into the mounting
holes located on the right side of the chop saw
base (Fig. H).
3. Thread the stop screw (5) and washer (6) into each
end of the extension bracket (Fig. H-l).
4.
Adjust the extension bracket (2) to the desired
position (Fig. H).
5. Tighten the locking screw (1) (Fig. H-l).
6. Adjust the stop block (4) for repetitive cutting by
L
I
_ ii --_ii
;
11
loosening the wing nut (3), sliding the stop block to
the desired position and locking in place.
Fig. H
3
2
Fig. H-1
1
6
THE LASER GUIDE
Your tool is equipped with the Laser Trac_ cutting guide,
a battery powered device using Class Ilia laser beams.
The laser beams will enable you to preview the abrasive
wheel path on the workpiece to be cut before you begin
your operation.
I,_ WARNING
I
• Do not stare into beam or view directly with
optical instruments. Do not remove the warning
label affixed to the wheel guard. Avoid direct eye
contact with light source.
• Laser Warning Label: Max. Output < 5 mW,
Wavelength: 630-660 nm, Complies with 21CFR
1040.10 and 1040. 11 Class Ilia laser product.
LASER
RADIATION-AVOID
DIRECT
EYE EXPOSURE
Max.0utput <5 mWWavelength: 630..660 nm
Complies _
21CFR 1040.10and1040.11
Class Ilia Laser Product
• CAUTION-Use
of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
• CAUTION-The
use of optical instruments with this
product will increase eye hazard.
• Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to repair
this laser product, serious injury may result.
Any repair required on this laser product should
be performed by authorized service center
personnel.
Advertisement
