Pressure Washer Rinsing; Automatic Cool Down System (Thermal Relief) - Craftsman 580.752300 Owner's Manual

6. Applydetergent toa drysurface, s tarting fromthe
bottom andworking up.
7. Allowdetergent to"soakin"for3-5minutes before
rinsing. R eapply a s needed toprevent s urface
fromdrying.
8. Forwashing, startat lowerportion ofareato be
washed andworkupward, u singlong,even,
ovedapping s trokes.
IMPORTANT: Youmustflushthechemical injection
system aftereachusebyplacing thefilterintoa clean
bucket o fwaterandrunning the pressure w asher in
lowpressure f or 1-2minutes.
Pressure Washer Rinsing
For Rinsing:
1. Slide nozzle backward to high pressure, press
trigger and wait for detergent to clear.
NOTE: You can also stop detergent flow by removing
detergent siphoning tube from container.
2. Keep spray gun a safe distance from area you
plan to spray.
3.
Apply a high pressure spray to a small area, then
check surface for damage. If no damage is found,
it is okay to continue cleaning.
WARNING
Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
4. Start at top of area to be rinsed, working down
with same overlapping strokes as you used for
washing and applying detergent.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging the warm water onto
the ground.
11