Table of Contents
Advertisement
Receiver and Remote Control Programming
SI:,CURITY,I;
To _r_3" _
_
rtO_ _tmm_mt Qrm_at_m
ot _
m
_mdto¢
trzmsm_r are _
exceptforchemglng l i_e€ode=etUngor mpi_ng
thebatter/.THEREARENO OTHERUSERSERVICEABLEPARTS.
Your garage door opener receiver and remote
controlhave been pre-set at the factory.The door
will open when you press the LARGE remote
controlpush button. The code between the remote
controland the receiver changes with each use,
randomly accessing over 100 billionnew codes.
The 3-function remote controlcan also activate
additionalSECURITY+ garage door openers and/or
light controls.
Your SECURITY,I, opener willoperate with:
• several SECURITY+ remote controls(with blue
push buttons) utilizing up to 8 functions.
• one SECURITY+ Keyless Entry System
(Model 139.53684).
Follow the instructionsbelow to program your
opener to match any additionalremotes you may
purchase. See Accessories on page 38.
Children operating or playing with a garage
door opener can Injure themselves or others.
The garage door could close and cause ser/ous
injury or death. Do not allow children to operate
the door push button(s) or remote control(s).
A moving garage door could Injure or kill
someone under It. Activate the opener only
when you can see the door clearly, it Is free of
obstructions, and Is properly adjusted.
To Add A Remote Control
If you have a Premium Control Console:
1. With the door closed, press and hold a remote
controlpush button. See Figure 1.
2. Press and hold the Light button on the door
control.
3. Press end hold the door controlpush button.
4. After the opener light flashes, release all buttons.
Test by pressing the remote push button.
If you do not have a Premium Control Console:
1. Press and holdthe selected remote control push
button.See Figure 1.
2. Then press and release the SRT (learn) button on
the back panel of the opener, Figure 2. The
indicator light on the panel will begin to blink and
the opener light will flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener panel
until the indicator light turns off (about 6 seconds).
All remote controlcodes are now erased. Then
follow the steps above to re-program each remote
control.
Figure I
SeLecta remote €ont_ _
_on
to operate opermr
SECURITY'I"
3-Function
Remote Control
Figure 2
SECURITY÷
Garage Door Opener
--
_
SRT(leam)
Indicator
BACK
_°
° ° ° °_'t
I
Button
Ughl
PANEL
N',
/Code
programming Instructlonl
are
also located on the opener panel.
33
Advertisement
Table of Contents
