Anti-Tip Device - GE JGB900 Owner's Manual & Installation Instructions

Installation Instructions
-&WARNING!
ANTI-TIP DEVICE
@
®
All ranges can tip and injury could
result.
To prevent accidental tipping of the rmage,
attach an approved Anti-Tip device to the
wall. (See Installing the Anti-Tip Device in
this section.) To check if the device is
installed and engaged properly, carefully
tip the range forward. The Anti-Tip device
should engage and prevent the range from
tipping over.
If you pull the range out from the wall for
rely reason, make sure the Anti-Tip device
is engaged when you push the rmige back
against the wall.
• For your sate(v, never use your range for wai_ning
or heating the
I'00111.
YO/II" ()veil alld cooktop ai'e
not designed to heat your kitchen. Top burnei_
should not be el)crated without cookware on tile
grate, Such abuse could result ill fire and daulage
to your range and will void your warrantv.
• Do not store or use cou/bustible inateYials,
gasoline or other flauunable wq)ors and liquids
ill the vicinity of this or ally other ai)pliance.
Explosions or fires could result.
• Do
Ilot rise ()veil toI" a storage area. ]telns stored ill
tile oven can ignite.
• Do not let cooking grease or other flau/nlable
u/atei'ials accuu/ulate ill or near tile range.
LOCATION
Do not locate the rmige where it may be subject to
strong drafts. Any openings in the floor or wall behind
the rm_ge should be sealed. Make sure the openings
around the base of the range that supply fresh air for
combustion and ventilation are not obstructed by
carpeting or woodwork.
Your range, like ulany other househt/ld items, is
heavy and can settle into soft floor coverings such as
cushioned vinyl or carpeting. Use care when n/oving
the range oil this type of flooring. It is i'econunended
that the tollowing siinple and inexi)ensive instit(ctions
be followed to protect your floor.
Tile range should be installed on a sheet (If plywood
(or siulilar n/aterial). When the floor covering ends at
the fl'ont of the range, the area that the range will rest
on should be built up with plywood to tile saule level
or higher than the floor covering.
This will allow tile range to be n/oved flIr cleaning
or servicing. _Mso, ulake sure your floor covering will
withstand 180°F. (See tile Installation Safety Instructions
section.)
Make
sure tile
wall
coverings ai'O/llld voui" range c}(ii
withstand tile heat generated (up to ')O0°F) bv tile
ran ,e (See tile
Installation Safety Instructions
section.)
IMPORTANT!
Remove all tape mid packaging. Make sure the
burners are properly seated m_d level.
Take the accessory pack out of the oven and/or
drawer,
Check to be sure that no range parts have come loose
during shipping.
42