Sharp XG-PH50X Operation Manual page 25

4.
Adjust the angle
Adjust the projector angle
• • • • • Shift the lens horizontally and vertically.
1 1 1 1 1 Press
on the projector or
remote control.
2 2 2 2 2 Press ', ", \ or | on the projector or the
remote control.
5.
Adjust the focus and the zoom
1 1 1 1 1 Press
on the projector or
2 2 2 2 2 Press
on the projector or
6.
Correcting the image distortion due to the projection angle
1 1 1 1 1 Press
on the projector or
remote control.
2 2 2 2 2 Press
on the projector or
remote control.
3 3 3 3 3 Press ', ", \ or | to move the position for
the upper left of the image.
7.
Select the input mode
Press on the projector or
• • • • • When pressing
Pressing on the projector switches between "INPUT 4" and "INPUT 5".
• • • • • When using the remote control, press
8.
Turn the power off
Press on the projector or
press or again.
• • • • • Disconnect the power cord from the AC outlet after the cooling fan stops.
on the
on the remote control to adjust the focus.
on the remote control to adjust the zoom.
on the
on the
on the remote control to select the "INPUT 1" mode.
" " " " On-screen Display (RGB) "
on the projector, input mode switches in order of :
/
on the remote control. While the confirmation message is displayed,
" " On-screen Display " "
"
• • • • • Adjust the projector angle by rotating the adjust-
ment feet.
4 4 4 4 4 Press
or
5 5 5 5 5 Repeat the same procedure with the positions
for the upper right, lower right and lower left
of the image.
• • • • • When the position of the lower left is set, the
correction is made and the display disappears.
/ / / to switch the input mode.
Pages 38, 39
Page 40
to set the position.
Page 41
INPUT 1 INPUT 2 INPUT 3
Page 45
Page 37
.
-21