Using The 20-Bin Sorter - Sharp AR-S11 Operation Manual

USING THE 20-BIN SORTER

1 Place the original in the document feeder
tray (when a
document feeder is installed) or on the
document glass. (Refer to page 4-6 of
"Operation manual
information and copier operation)".)
2 Select copy settings as needed, including
two-sided or one-sided copy mode, paper
size select, exposure adjustment, and
copy ratio. (Refer to chapter 5 of
"Operation manual
information and copier operation)".)
Touch the [OUTPUT] key.
3
2-SIDED COPY
OUTPUT
Touch the [SORTER] key.
4
READY TO COPY.
OUTPUT
SORTER
SORT
GROUP
NOTES
G G G G Maximum number of original pages
This is the maximum number of original pages that can be copied at once in sort mode or group mode.
In sort mode: The limit is the same as the maximum number of sheets that can be held in one bin. (See *1 in
the "SORTER CAPACITY" table on page 3.)
In group mode: Up to 20 sheets (the same as the number of bins in the sorter).
G G G G Maximum number of copies that can be set
The maximum number of copies that can be set in sort mode and group mode is as follows:
In sort mode: Up to 20 copies (the same as the number of bins in the sorter)
In group mode: The number of sheets that can be held in one bin (See *2 in the "SORTER CAPACITY" table on page 3.)
G When "Transparency film with insert sheets" or "A3 (11" x 17") Full-bleed" is selected (these are special
functions), the copies are output in non-sort mode. Sort and group modes cannot be selected.
G To cancel a copy run, press the [CLEAR] key. Copying will stop and the number in the copy quantity display will
be reset to 0.
reversing automatic
(for general
(for general
5 Touch the key for the desired output
mode.
READY TO COPY.
OUTPUT
NON SORT
SORTER
SORT
GROUP
the original was placed in the document feeder tray,
sort mode is automatically selected.
6 Touch the [OK] key.
0
INTERRUPT
OK
CENTRE TRAY
7 Set the number of copies as needed and
press the [COLOUR COPY START (
or [BLACK COPY START (
The touched key is
highlighted to indicate
that the function is
enabled.
If the original was placed
on the document glass in
step 1, non-sort mode is
automatically selected. If
)]
)] key.
Replace the original with
the next original and
press the [START] key.
Repeat this operation
until all originals have
been scanned.
5