Displaying Dual Pictures (Pict In Pict); Displaying The Inset Picture - Sharp Notevision XG-C58X Operation Manual

Displaying Dual Pictures
Picture in Picture function allows you to display two pictures on the same screen. You can
display the image input from INPUT 3 or 4 as an inset picture overlapping the main picture
from INPUT 1 or 2.

Displaying the Inset Picture

1
Press .
2
Press or
control or
to switch the image in the in-
set picture .
3
Press ' ' ' ' ' , " " " " " , \ \ \ \ \ and | | | | | to set the
position of the inset picture.
• Press to stop the frame from mov-
ing or to make the frame disappear.
4
Press to move the inset pic-
ture.
• The inset picture will be moved to the
inset picture frame.
Note
• The inset picture can only be displayed
with composite video (NTSC/PAL/
SECAM) or S-Video signal.
• The Freeze function works only with the
inset picture, when the Pict in Pict mode
is in operation.
When the signal entered into INPUT 1 or 2
is as follows, Pict in Pict does not work:
• With a resolution that exceeds SXGA.
• When the input signal is 480
I,
540P, 576 576P, 720P, 1035
• When the input signal has changed to
the Interlace mode using RGB signals.
• When the picture display mode is set to
"DOT BY DOT".
• When no signals are sent to INPUT 1 or
2, or when the resolution or refresh rate
(vertical frequency) is changed.
on the remote
on the projector
I
, 480P,
I I
or 1080 .
(Pict in Pict)
UNDO button
ENTER button
' " \ |
, , , buttons
PinP button
INPUT 3/4 buttons
-57