Removing And Installing The Lamp Unit - Sharp Notevision XG-C58X Operation Manual
Hide thumbs
Also See for Notevision XG-C58X:
- Specification sheet (2 pages) ,
- Service manual (172 pages)
Table of Contents
Advertisement
Regarding the Lamp
Removing and Install-
ing the Lamp Unit
Info
• Make sure that you remove the lamp by
the handle. Do not touch the glass sur-
face of the lamp unit or the inside of the
projector.
• To avoid injury to yourself and damage
to the lamp, ensure to carefully follow the
steps below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened).
1
Press
on the projector
STANDBY
or
on the remote control to
put the projector into the
standby mode.
• Wait until the cooling fan stops.
Warning!
• Do not remove the lamp unit from the
projector right after use. The lamp will
be very hot and may cause burn or
injury.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3
Change the air filter.
• Change the air filter whenever you in-
stall the lamp unit (see pages
81
and
82).
4
Remove the lamp unit cover.
• Loosen the user service screw that
secures the lamp unit cover. Then
open the cover in the direction of the
arrow.
-86
Lamp
AN-C55LP
unit
STANDBY button
STANDBY
button
AC socket
User service screw
Advertisement
Table of Contents
