Configuring The Printer Driver; Connecting A Parallel Cable - Sharp AR-M160 Software Setup Manual

CONNECTING A PARALLEL CABLE

1
Ensure that your computer and the
machine are turned off.
2
Plug the cable into the parallel port on
the machine, and fasten with the clasps.

CONFIGURING THE PRINTER DRIVER

After installing the MFP driver (printer driver), you must configure the printer driver settings appropriately for the
number of paper trays on the machine and the size of paper loaded in each.
1
Click the "start" button, click "Control
Panel", click "Printers and Other Hardware",
and then click "Printers and Faxes".
In operating systems other than Windows XP, click the
"Start" button, select "Settings", and then click "Printers".
2
Click the "SHARP AR-XXXX" printer
driver icon and select "Properties"
from the "File" menu.
If you are using Windows NT 4.0/2000/XP, go to step 4.
3
In Windows 95/98/Me, click the "Setup" tab.
4
Click the "Configuration" tab and set
the printer configuration based on the
options that have been installed.
Set the printer configuration properly. If not,
printing may not take place correctly.
CONNECTING TO A COMPUTER
3
Plug the other end of the cable into
your computer's parallel port.
5
Click the "Set Tray Status" button and
select the size of paper that is loaded
in each tray.
Select a tray in the "Paper source" menu, and
select the size of paper loaded in that tray from the
"Setting Paper Size" menu. Repeat for each tray.
If the dual function board is not installed, be sure
Caution
to configure the above "Set Tray Status"
settings, and then when printing specify a tray
other than "Auto Select" in "Paper Source" in the
"Paper" tab of the printer driver setup screen.
6
Click the "OK" button in the "Set Tray
Status" window.
7
Click the "OK" button in the printer
properties window.
11