Washable Active Carbon Filter Care - Sharp FU-W28J Operation Manual

WASHABLE ACTIVE CARBON FILTER CARE

WASHABLE ACTIVE CARBON FILTER CARE
HAND WASH ONLY!
DO NOT TUMBLE DRY!
Care Cycle
We recommend replacing the active carbon filter every six months.
Clean the filter as offen as necessary when odour persists.
1
Fill a large container with
lukewarm water, add a mild
kitchen detergent and stir.
D i l u t e a s i n d i -
cated on the de-
tergent container.
2
Allow the filter to soak ap-
proximately 10 minutes .
3
R i n s e t h o r o u g h l y w i t h
clean water.
CAUTION
I f r i n s i n g i n a
c o n t a i n e r, b e
sure to rinse 3
t o 4 t i m e s s o
that the odour is
rinsed thorough-
ly from the filter.
4
Remove excess water.
The filter will be saturated with wa-
ter after rinsing. To decrease drying
time, wrap the filter in an old thick
towel so that excess water can be
removed.
CAUTION
Some carbon
may adhere to
t h e t o w e l , i f
you towel-dry
the filter, but it
is harmless.
5
Dry filter completely in a well ventilated
area. If possible, dry outdoors.
CAUTION
• Avoid drying filter outdoors during inclement
weather (e.g. rain or cold temperatures).
• Do not allow filter to freeze.
• If filter is dried indoors, take precautions, such as
placing towels, etc under the filter to prevent wa-
ter damage to the floor.
6
Reinstall the Filters.
Reinstall the filters as shown on Page E-6,7.
Dry filter completely before replacing to pre-
vent odours.
Do not operate unit without all filters properly
installed.
Filter Support
Active Carbon
Filter
HEPA Filter
Main Unit
E-11