Sharp PG-D2870W Setup Manual page 16

Setting up the Projector Network Environment
4 4
The TCP/IP setting screen
appears, ready for network
settings for the projector.
Items
New You can set the password to protect
Password the TCP/IP setting.
DHCP Select "ON" or "OFF" to determine
Client whether to use DHCP Client.
IP You can set this item when "DHCP
Address Client" is set to "OFF".
Factory default setting: 192.168.150.2
Enter an IP address appropriate for
the network.
Subnet You can set this item when "DHCP
Mask Client" is set to "OFF".
Factory default setting:
255.255.255.0
Set the subnet mask to the same as
that of the computer and equipment
on the network.
Default You can set this item when "DHCP
Gateway Client" is set to "OFF".
Factory default setting: 0.0.0.0
* When not in use, set to "0.0.0.0".
DNS Factory default setting: 0.0.0.0
Server * When not in use, set to "0.0.0.0".
Note
• Confi rm the existing network's segment (IP
address group) to avoid setting an IP address
that duplicates the IP addresses of other
network equipment or computers. If
"192.168.150.2" is not used in the network
having an IP address of "192.168.150.XXX", you
don't have to change the projector IP address.
• For details about each setting, consult your
network administrator.
5 5
Click the "Apply" button.
6 6
The set values appear. Confi rm
that the values are set properly,
and then click the "Confi rm"
button.
• Close the browser.
• This completes the network settings.
• After setting items, wait for about 15 seconds and then re-access.
• Change the IP address of the setting computer back to its original address, which you have noted down in
Step 6-1 on page 14, and then connect the computer and the projector to the network.
-16
Setting example / Remarks