Preparation; Inserting Batteries In The Remote Control; Remote Control Use - Sharp FU-28H Operation Manual

PREPARATION

INSERTING BATTERIES IN THE REMOTE CONTROL

About the batteries
• The battery life is about 1 year.
• Replace the batteries when the remote control becomes inoperative.
• Incorrect usage of the batteries may cause battery fluid leakage and/or
damage. Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of the same
type. (Use R6 (AA) manganese batteries (2 units).)
• When not using the unit or remote control for an extended period, remove the
batteries. This prevents malfunction of the remote control from battery fluid
leakage.
• The batteries of the accessory are for initial use only and may be depleted
within 1 year.

REMOTE CONTROL USE

• Operate the remote control facing the main unit receiver.
• The signal range is about 7m (front).
• Make sure there are no objects blocking the path of the signal.
• A beep sound will be heard from the main unit when a signal is received.
NOTE
• Avoid dropping or damaging the remote control,
using in a high humidity condition, in direct sun-
light or near a heat source.
1
Remove the back cover
Press and slide the back cover to remove.
2
Insert batteries
Insert batteries with
below.
3
Close the back cover
Transmitter
E-5
and as shown
Receiver