Table of Contents
Advertisement
3
Apply a mark (tape, etc.) 8 cm above both ends of the wall mounting
bracket.
4
Lift up the unit so that the hooking holes on the unit are aligned with
the marks, hook the unit onto the wall mounting bracket and slide it
to the right.
When positioned correctly, the unit will move down slightly until it
engages.
Alignment with the right hooking holes
mark
claw socket
Alignment with the left hooking holes
about 8 cm
5
Double-check the installation.
Make sure that the claws of the unit are hooked in properly. If they are
not, the unit will move sideways. In addition, the unit may fall off the
wall and be damaged.
• Make sure that the power cord is not caught in the unit.
6
Remove the mark.
HOW TO REMOVE THE UNIT
Pull the power plug out of the wall outlet and remove
the Front Panel and Filter Frame. Holding the unit by
its lower corners, lift it up slightly, then slide it to the
right or left and lift it off toward the top.
about 8 cm
mark
claw socket
E-9
Wall mounting bracket
1
2
2
1
2
Advertisement
Table of Contents
