Automatic Projection By Schedule (Timer Setup) - Epson POWERLITE 8300I EMP-8300 Operation Manual

Setting EasyMP.net Options (EasyConfiguration)
Buffer Set a network buffer size. This is the amount of
information that is stored before a file or a stream file is
played back by EasyPlayer.
Specify the buffer size within the range of 1 to 60.
Connection speed Select a network connection speed.
Protocols Select a protocol for streaming file reception. We
recommend you select all protocols here.
If a firewall is used on the network or if you do not wish
to use specific protocols, uncheck those protocols.
A specific port can be set for the "Port" of the UDP.
Proxy setup Set a proxy value for the proxy server used for each
protocol. However, the proxy setup is not required if no
firewall is used.
The protocol operation can be set on the proxy server
when each protocol is clicked.
Proxy setup procedure Select one of the following options.
- The proxy setup is detected automatically.
HTTP (Recommended)
MMS This allows you to automatically detect an open port
RTSP and receive a stream via the port.
- Use the proxy setup of EasyBrowser.
This allows you to access the network using the same
configuration as EasyBrower.
- Do not use the proxy server.
EasyPlayer does not communicate with the proxy
server. If this option is selected, no stream will be
received from the Internet.
- Use the next proxy server.
This allows you to use the following proxy server and
port to receive a stream.
Address Enter the
Port Enter the port number of the proxy server you use.
Bypass proxy If checked, EasyPlayer is not connected to the proxy
server for local server when a stream sent from the local server is
address received.
Dose not use the Enter the URL of the local server used for stream
proxy at the next distribution.
and subsequent
addresses.
IP address of the proxy server you use.

Automatic Projection by Schedule (Timer Setup)

Timer
Automatic projection starts if "Create New Timer" is clicked and the timer
is set. Up to 10 timer schedules can be registered.
Start Date & Time Select the Date & Time, Every Day and Every Week,
and enter the start time.
Operation Time Specify the projector operation time in minutes. If "Not
specified" is selected, the projector continues to operate
until there are no images left.
Video Source Specify the source of the images to be projected.
Operation Specify the projection file and address.
EasyMP.net Enter the file path in EasyMP.net you wish to project
(e.g. everyone/easymp.jpg). The application will start
from EasyMP.net.
Network Enter the file path of the network PC (e.g. //epson/
Computer share/easymp.jpg). An application that can open the file
is called from the PC.
The user ID and password are also required for system
logon.
URL Enter the URL of the web page (e.g. http://
www.epson.com/) you wish to display using
EasyBrower.
Play Settings Set the following parameters for the slideshow file
included in the folder you have specified in "Operation"
- "EasyMP.net".
Slideshow Play Specify a time interval between slides. The timer
Interval interval can range from 0 to 300 seconds.
Slideshow Select the special effects during slide change.
Playback Effects
Repeat Play Select "ON" to repeat the play.
EasyMP .net Operation Guide
22