Timer On - Sharp AY-XM12CR Operation Manual

TIMER ON

AM
DISPLAY
FULL
POWER
MODE 1h
FAN
SWING CLEAN
SET/C
The PLASMACLUSTER and the SELF CLEAN buttons
are provided only on models AY-XPM7CR/AY-XPM9CR/
AY-XPM12CR.
COMBINED USE OF ON AND OFF TIMERS
You can use the ON and OFF timers in combination.
AM
PM
NOTES:
• You cannot programme the ON-TIMER and OFF-TIMER to operate the unit at
different temperatures or other settings.
• Either timer can be programmed to activate prior the other.
1
Press the TIMER ON (
2
The TIMER ON indicator will blink; press the TIME
ADVANCE or REVERSE buttons to set the de-
sired time. (The time can be set in 10-minute
increments.)
3
Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it receives
the signal.
4
Select the operation condition.
1
• The unit will turn on prior to the set time to allow
the room to reach the desired temperature by
the programmed time. (Awaking function)
2
• If unit(s) is/are operated in one mode while
TIMER ON is set with another unit in different
3
mode, the timer may not activate the required
operation.
Example:
To stop operation at 11:00 p.m. and resume opera-
tion (With the same mode and temperature settings)
to bring the room temperature to the desired level by
7:00 a.m.
1
Set the TIMER OFF to 11:00 p.m. during opera-
tion.
2
Set the TIMER ON to 7:00 a.m.
The arrow (
indicator and the TIMER OFF indicator shows which
timer will activate first.
E-15
) button.
) on the unit will
or ) between the TIMER ON