Easy Camera Recording On Tape In Full Auto Mode - Sharp ViewcamZ VL-Z7S Operation Manual

Basic Operations
Camera Recording
Easy Camera
Recording on Tape in
Full Auto Mode
Available mode:
Tape Camera
• Before you start recording, perform the
operations described on pages 6 through
20 to prepare your camcorder for
recording.
Media Selection switch
Start/Stop button
1
Remove the lens cap.
2
Set the Media Selection
switch to V.
3
Hold down the Lock button and set
the Power switch to v.
• The picture from the lens now
displays and the POWER/CHARGE
(RED) indicator lights up green.
• The camcorder is now ready to
record (Recording Standby mode).
POWER/CHARGE
(RED) indicator
A U T O A U T O
Lock button
Note:
• If "AUTO" is not displayed at this time,
set the camcorder to Full Auto mode
(see page 58).
22
4
Press the Start/Stop button to begin
recording.
Note:
• Before recording an important scene,
please perform the recording test, then
playback to check if the scene was
recorded properly. If noise occurs, use a
commercially available cleaning tape to
clean the video heads (see page viii).
Maximum continuous recording and
actual recording times in Tape
Power switch
Camera mode
Battery
pack
BT-L226
Note:
• Using the zoom (see page 23) and other
functions or turning the power on and off
frequently will increase power consump-
tion. This may result in a decrease in the
actual recording time compared to the
maximum continuous recording time listed
above.
R E C
Max. continuous Actual
recording time recording time
LCD LCD LCD LCD
closed open closed open
115 100 55 50