To Record From An External Source - Sharp VL-Z500H Operation Manual

To Record from an External
Source
1
In Tape Playback mode, press the
MENU button to display the menu
screen.
2
Press l or m on the Operation
button to select Z, then press the
centre of the Operation button.
3
Press l or m to select "S-VIDEO
IN", then press the centre of the
Operation button.
O T H E R S 1
D E F A U L T
R EMO T E
B E E P
S - V I D E O I N
R E T U RN
4
Press l or m to select "ON" (for S-
video connection) or "OFF" (for video
connection), then press the centre of
the Operation button.
5
Press the MENU button to turn off the
menu screen.
• "S-VIDEO" appears on the screen
during a pause or Recording
Standby mode when you set the S-
VIDEO IN menu item to "ON" in step
4 above.
6
Begin playback on the source
equipment connected to the
camcorder.
• Check the camcorder screen to see if
the picture is properly received.
7
Press the Record Start/Stop button
on the camcorder, then press m to
begin recording.
Notes:
• To pause recording, press m. Press m again
to resume recording.
• To operate by remote control, perform steps 1
to 6 above, and press the TAPE REC START/
STOP button, then press the PLAY/STILL
button (g).
• If a digital video recording with a copyright
protection signal is used as the playback
source, "COPYRIGHT PROTECTED."
appears on the camcorder monitor and the
recording function is disabled.
O F F
ON
69