To Record From An External Source - Sharp VIEWCAMZ VL-Z5E Operation Manual

To Record from an External
Source
1
In Tape Playback mode, press the
DISPLAY button until the mode
screen appears.
2
Select "MENU", then "EXECUTE" by
using the Operation button (see page
32).
3
Press l or m to select ~, then
press the centre of the Operation
button.
4
Press l or m to select "S-VIDEO
IN", then press the centre of the
Operation button.
O T H E R S 2
T I ME CO D E
T C OU T
S - V I D E O I N
R E T U RN
5
Press l or m to select "ON" (for S-
video connection) or "OFF" (for video
connection), then press the centre of
the Operation button.
6
Press the DISPLAY button to turn off
the menu screen.
• "S-VIDEO" appears on the screen
during a pause or Recording
Standby mode when you set the S-
VIDEO IN menu item to "ON" in step
5 above.
7
Begin playback on the source
equipment connected to the
camcorder.
• Check the camcorder screen to see if
the picture is properly received.
8
Press the Start/Stop button on the
camcorder, then press m to begin
recording.
Notes:
• To pause recording, press m. Press m again
to resume recording.
• To operate by remote control, perform steps 1
to 7 above, and press the TAPE REC START/
STOP button, then press the PAUSE/STILL
button (g).
• If "NO SIGNAL" is displayed on the
camcorder screen, check that the audio/
video/S-video cable is properly connected.
• If a digital video recording with a copyright
protection signal is used as the playback
source, "COPYRIGHT PROTECTED."
appears on the camcorder monitor and the
recording function is disabled.
O F F
ON
65