Still Recording On Tape - Sharp ViewCam VL-WD450E Operation Manual

Still Recording on Tape

You can record still images of subjects with
normal sound on a tape by selecting one of two
still recording modes.
Type of Still Recording modes
SNAP: A still picture is recorded for 6 seconds.
STILL: A continuous still image is recorded.
Selecting Still Recording Mode
1
Set the camcorder to TAPE-CAMERA
mode.
2
Press the MENU/DISPLAY button until
the menu screen appears.
3
Select Y, then press r on the
Operation button. Select "SNAP EFF."
(1), then press r (2).
CAMERA SE T
PHOTO SNAP
SNAP
DG T L ZOOM
T AP E SP E E D
1 6 9
4
Press d or y to select "OFF", then
press e.
SNAP E F F.
5
Press y (1) to select "PHOTO
SNAP", then press r (2).
CAMERA SE T
PHOTO SNAP
SNAP
DG T L ZOOM
T AP E SP E ED
1 6 9
E F F. OF F
PHOTO SHOT
P- I N- P
: 9 F RAME S
1 6 F RAME S
OF F
SNAP
E F F. S T I L L
:
6
Press d or y to select the desired
still recording mode, then press e.
PHOTO SNAP
7
Press the MENU/DISPLAY button to
turn off the menu screen.
Using Still Recording
1
Set the camcorder to TAPE-CAMERA
mode.
2
In Recording Standby
mode, press the STILL
button.
• A still image of the subject
is displayed.
3
Press the REC START/STOP
button.
• The still image of the subject
will be recorded.
In SNAP mode, the camcorder returns to
Recording Standby mode after recording
a still image for 6 seconds.
To pause recording
Press the REC START/STOP button.
To cancel the still image
In SNAP mode, press the STILL button while
the camcorder is in Recording Standby
mode.
In STILL mode, press the STILL button.
Notes:
• Still Recording can also be used during
recording by pressing the STILL button.
• The picture quality in Still Recording mode will
be slightly lower than normal pictures.
S T I L L
38