Sharp AE-M18AE-T Operation Manual page 9

NOTES:
This air conditioner is a multi-type, and two indoor units are connected to
one outdoor unit.
When the setting mode of one indoor unit differs from the other, the indoor
unit operated later may not work.
» When one indoor unit is operating in HEAT mode, the other unit can not operate
in COOL or DRY mode.
» When one indoor unit is operating in COOL or DRY mode, the other unit can not
operate in HEAT mode.
When the mode of the indoor unit later operated is different from
the one which is in operation, the red BUSY lamp (
indoor unit later operated will blink.
How to reset the BUSY lamp
There are two ways to reset the blinking BUSY lamp (
Change the remote control's mode and send the same mode signal which
the other indoor unit is operating in, or push the ON/OFF button of the
remote control.
TIPS ABOUT AUTO MODE
In the AUTO mode, the temperature setting and mode are automatically
selected according to the room temperature when the unit is turned on.
Room temp. at opera-
tion start-up
Below 21°C
21°C-24°C
24°C-26°C
26°C-28°C
Above 28°C
( )
Automatic Operation
Mode Thermostat Setting
HEAT
DRY Room Temp. at start-up
COOL
COOL
COOL
E-7
) of the
) .
23°C
24°C
25°C
26°C