TEST RUN MODE
Use the test run mode only for a test operation. Do not use the test run mode for other
than operation testing since the thermostat control is inactive in this mode and the unit
remains in continuous operation.
Make sure the unit is turned off before conducting a test run.
TO TURN ON
Lift the front panel of the indoor unit and press the
TEST RUN button on the operation panel.
» The red OPERATION lamp (
blink and the unit will start operating in the COOL
mode.
» The temperature setting is not set. (the compressor
runs continuously.)
TO TURN OFF
Press the AUX. button on the operation panel.
» The red OPERATION lamp (
turn off.
NOTE:
» To conduct a heat mode test run, press the MODE
button on the remote control to set the unit in the
HEAT mode.
) on the unit will
) on the unit will
E-12
TEST
AUX.
RUN