Using The Vr-33Ch Car Battery Adapter/Battery; Charger Or The Vr-41 Oca Car Battery Adapter - Sharp VL-E78E Operation Manual

Preparation
Using the VR-33CH Car Battery
Adapter/Battery Charger or the
VR-41 OCA Car Battery Adapter
(Optional Accessories)
Use the optional VR33CH car battery adapter/battery
charger (or the VR-41 OCA car battery adapter) when
you want to power the VIEWCAM from the cigarette
lighter socket of your car.
Perform steps 1 through 3 under "Powering the
VIEWCAM from an AC Outlet" (page 12).
Plug the DC cable into the DC OUT jack on the
VR-33CH (or VR-41 OCA).
Next, start the car engine and leave it idling. Then
insert the plug into the cigarette lighter socket. (The
POWER indicator on the VR-33CH will light.)
---------------------~._~~____7
i When powering from
I
i
your car's cigarette lighter
I
I
I
ar battery adapter
DC OUT jack i
or
l
See the VR-33CH (or VR-410CA) operation
manual for details.
l
The VR-33CH can be used to recharge the battery
packs. Refer the operation manual for further
details. While the VR-41 OCA cannot be used as a
'II
battery pack charger.
;i;
x
l
Use in only DC 12 V or 24 V negative ground
system cars. Positive-ground car batteries
CANNOT BE USED. Check your car operation
manual or consult a local car dealer.
l
Use the VR-33CH (or VR-410CA) only when the
car is idling or being driven. Otherwise, the car's
battery will be drained.
l
Charge only SHARP model BT-H21 or BT-N1
battery packs. Other types of batteries may burst,
causing personal injury and damage.
l
Before starting the car engine, the VR-33CH (or
VR-410CA) must be unplugged from the cigarette
lighter socket.
l
Before removing either the DC plug or the cigarette
lighter plug, the VIEWCAM's Power switch should
be set to OFF.
I_
I
I
I
I
I
I
I
I
I
I
I
I
Car battery adapter
VR-41 OCA
(optional
I
----------------a---._.--------J
13101
-