Charging The Battery Pack - Sharp ViewCam VL-AH131E Operation Manual

Preparation

Charging the Battery Pack

CHARGE indicator
1
Insert the battery pack into the VIEWCAM
(see page 8). Make sure that the Power
switch is set to OFF.
• The battery pack will not charge when the
Power switch is set to CAMERA or VCR.
2
Connect the power cord to the AC adapter,
then insert the AC plug into a power outlet.
3
Open the terminal cover on the VIEWCAM
and insert the DC plug of the AC adapter
into the DC IN jack on the VIEWCAM.
• The CHARGE indicator will light up in red.
DC IN jack
To power
outlet
4
When the battery is fully charged, the
CHARGE indicator will light up in green.
Remove the DC plug from the VIEWCAM,
and close the terminal cover.
Caution:
• When removing the plugs, grasp the plug, not the
cable.
9
Power switch
Terminal cover
Charging time and maximum continuous
recording and playback times
Battery Charging continuous
pack time recording
approx.
BT-H22
3 hr. 1 hr. 40 min.
approx.
BT-H32
6 hr. 3 hr. 20 min.
Notes:
• Using the zoom (see page 17) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than 50%
in the actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may vary
depending on the ambient temperature and the
condition of the battery pack.
• It is recommended that you have enough battery
packs on hand to provide two to three times your
estimated recording time.
• See page 50 for more information on using the
battery pack.
Caution:
• Charge only SHARP model BT-H22 or BT-H32
battery packs. Other types of battery packs may
burst, causing personal injury and damage.
Max. Max.
continuous
playback
time time
approx. approx.
1 hr. 40 min.
approx. approx.
3 hr. 20 min.