Installing The Lithium Memory Battery - Sharp ViewCam VL-AH131E Operation Manual

Installing the Lithium
Memory Battery
The supplied lithium battery is used to store the
memory of the date and time settings.
1
Slide the cassette compartment door
release and open the cassette
compartment door.
Cassette compartment
door release
Note: The cassette holder will extend and
open when the VIEWCAM is connected to a
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 11).
2
Pull out the lithium battery holder using
a pointed object such as the tip of a
ballpoint pen.
Lithium battery holder
3
Insert the lithium battery
into the battery holder with
the ` side of the battery
facing the j side of the
holder.
4
Push the battery holder back
into position.
5
Removing the Lithium Battery
Perform steps 1 and 2 above, then lift out the
battery from the battery holder.
Note:
• Replace the battery with a new CR2025 battery
when the date and time indicator starts to fall
behind the correct time.
Notes on the Use of the Lithium
Battery
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recommended
by the equipment manufacturer.
WARNING
CHILDREN. IF SWALLOWED, CONSULT A
PHYSICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
CAUTION
USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
• Do not short-circuit, recharge, disassemble,
or heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment and holder clean, and
then insert a new battery.
• The lithium battery will last about one year of
normal usage.
j mark
Close the cassette compartment door by
pressing the centre until it clicks into
place.
KEEP THIS BATTERY AWAY FROM
BATTERY MAY EXPLODE IF MIS-
12