Automatic Rearming; Valet Mode; Driver Calling/Page Feature - Scytek electronic Vectra X3 Product Manual

6. Turn off the ignition then arm the system.
7. Disarm the system using the new Override Code to permanently store the new code.
Note: If the code set procedure is not properly performed, turn off the ignition and begin again. The override
code will not be permanently stored until the code is used to disarm the system.

Automatic Rearming

The Automatic Rearming feature is designed to protect the vehicle in the event the system is
accidentally disarmed.
automatically rearm and lock 30 seconds after disarming.
* Note Door open trigger does not stop the Rearm Cycle

Valet Mode

The Valet Mode temporarily disables the security system so the vehicle may be operated by a
mechanic or parking attendant.
To activate or deactivate the Valet Mode:
1. Turn on the ignition.
2. Press and hold the override switch for 5 seconds.
· The siren will chirp once and the LED light will stay ON to confirm the Valet Mode is
on.
· The siren will chirp twice and the LED light will turn OFF to confirm the Valet Mode is
off.
3. Turn off the ignition.
While in Valet Mode the remote transmitters will continue to lock and unlock the doors, and
operate the optional auxiliary functions.

DRIVER CALLING/PAGE FEATURE

The VECTRA X3 is equipped with a Driver Calling or Paging feature that allows the system to send
a page to the LCD transmitter in the event the transmitter has been misplaced or lost (within 1500 feet)
To activate the Driver Calling/Page feature:
1.Locate the Valet/Emergency Override button in your vehicle (Ask your installation shop)
· With the ignition switch OFF, press and hold the Valet/Emergency override button for 2
seconds, then release.
· The LCD transmitter will beep continually and the "DRIVER CALLING" icon will appear
· Press and release button 5 to turn off transmitter page.
With the Automatic Rearming feature enabled, the alarm will
VECTRA X3 - Page 11