Scytek electronic Galaxy 2000RS-2W-DBP Product Manual page 20

P r o g r a m m
P r o g r a m m
Pressing and holding transmitter button 5 will scroll through several transmitter programmable
options - TEMPERATURE, ENABLE COLD START, ENABLE HOT START, VALET MODE,
ENABLE AUTOSTART 1, ENABLE AUTOSTART 2.
TEMPERATURE Check the temperature inside the vehicle
1. Press and hold Button 5 until the display shows TEMPERATURE
2. Release Button 5.
· The transmitter will beep four times.
ENABLE COLD START Auto Start Cold Temperature Activation Mode.
1. Press and hold Button 5 until the display shows ENABLE COLD START.
2. Release Button 5.
· The transmitter will beep.
· The display will show Auto Start Cold Temperature setting.
3. Press and hold Button 5 until the display shows CONFIRM.
4. Release Button 5.
· The transmitter will beep.
· The display will show "FEATURE ON" indicating that Auto Start Cold Temperature Activation
Mode is enabled.
ENABLE HOT START Auto Start Cold Temperature Activation Mode.
1. Press and hold Button 5 until the display shows ENABLE HOT START.
2. Release Button 5.
· The transmitter will beep.
· The display will show Auto Start Cold Temperature setting.
3. Press and hold Button 5 until the display shows CONFIRM.
4. Release Button 5.
· The transmitter will beep.
· The display will show "FEATURE ON" indicating that Auto Start Cold Temperature Activation
Mode is enabled.
VALET MODE Valet mode function sets and resets the security system valet mode.
** this function is enabled only when the system is disarmed/ unlocked.
Set or reset the Valet mode:
1. Press and hold Button 5 until the display shows VALET or DISARM.
· The transmitter will beep.
2. Release Button 5.
· The display will show VALET MODE .
· The transmitter will beep twice and the siren will chirp twice if the Valet
mode was reset. The symbol.
ENABLE AUTOSTART 1, ENABLE AUTOSTART 2
1. Press and hold Button 5 until the display shows ENABLE AUTOSTART 1 or
ENABLE AUTOSTART 2
2. Release Button 5.
· The transmitter will beep.
· The display will show Auto Start 1 or 2 time setting.
3. Press and hold Button 5 until the display shows CONFIRM.
4. Release Button 5.
· The transmitter will beep.
· The display will show "FEATURE ON" indicating that Auto Start 1 or 2 Activation
Mode is enabled.
Page 16 - Galaxy 5000RS-DBP
a b l e F u n c t
a b l e F u n c t
i o n s u s i n g
i o n s u s i n g
t h e C o l o r R
t h e C o l o r R
AUTOSTART 1
TIME: 8:00A
AUTOSTART 2
TIME: 5:00P
e m o t e
e m o t e