Table of Contents
Advertisement
Adding/Replacing Standard Remote Transmitters
To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired
transmitters ready and follow the steps below.
Note: Up to 4 one-way transmitters can be programmed to operate the system. Any previously stored
transmitter will be erased if it is not programed within the following sequence
To program the transmitter(s):
1. Turn the ignition key On, Off, On, Off, and back On. (Key On 3 times)
· 3 seconds later The siren/horn will chirp/honk 3 times.
2. Press and hold the Override switch for 5 seconds.
· The siren/horn will chirp/honk 5 times.
· The LED will illuminate.
3. Press Button 1 on the first transmitter.
· The siren/horn will chirp/honk once.
4. Press Button 1 on the first transmitter again.
· The siren/horn will chirp/honk twice to indicate it has learned the code.
5. Repeat steps 3 and 4 for each transmitter (up to 4).
6. Turn off the ignition key.
Two Car Operation
If two vehicles are equipped with the Galaxy 5000RS Series systems, for convenience both can be operated
using the same remote transmitter. If all four transmitters are to be used with both cars, program
transmitters A and B into the first vehicle in the manner described above. Program transmitters C and D
by pressing the Shift button twice before performing steps 3 and 4 above.
When finished programming the first vehicle, program transmitters C and D into the second vehicle as
normal, then program transmitters A and B by pressing the Shift button twice before performing steps 3
and 4 above.
When programmed in this manner, the driver of the first car can also operate the second vehicle by pressing
the Shift button twice and the desired function button.
Battery Replacement
The T5-SP Remote Transmitter uses two 3 volt lithium batteries (type CR2016)
The T5 Remote Transmitter uses a 12 Volt lithium battery (type GP23A) which will require
replacement in time. Depending on the amount of use, the batteries may last up to six months
or more before they need replacement.
In order to change the battery, first remove the screw from the back of the transmitter and separate the
top and bottom halves of the case. While replacing the battery make sure that the positive and negative
terminals are positioned correctly, then carefully reassemble the transmitter case.
Galaxy 5000RS
- Page 3
Hide quick links:
Advertisement
Table of Contents
