GE 2200 Owner's Manual page 9

The Agitator Cap or Fabric Softener Dispenser (depending on model)
Theagitatorcap fits into the top of the ['j] Add water to dispenser until it reaches
agitator. If it accidentally comes off, simply _ tile maximum fill line.
put it back on.
Thefabricsoftenerdispenserautomatically
releases liquid fabric softener at tile
proper time during the (),(le.
Donot stop the washerduring the fkst spin.
Thiswill causethe dispenserto emptytoo soon.
Touse,follow these steps:
[-_ Make sure dispenser is securely
attached to agitator.
[_U se only liquid fabric softener. Pour
into dispenser, using amount
recommended on package.
Neverpour fabricsoftenerdirectlyon clothes.
/t may stain them.
Do not pour anything into the agitatorif flTe
agitator cap or dispenser is removed.
Separate for cleaning.
Cleaning the Fabric Softener Dispenser (on some models)
Ff] Remove the dispenser from tile top of the agitator.
[_ Separate tile dispenser (up fiom tile (over by g_vlsping tile top and pushing down on
the inside of the cup with your fingers. Dispenser cup x_411 pop flee fiom the cover.
t-j] To (lean the dispenser, soak both the dispenser (up and the dispenser (over in the
fi)llowing solution:
• 1 Uggallon(3.8 liters) warm water
• 1/4cup (60m/) heavyduty liquid detergent
• I cup(240m/) bleach
[_]If necessatT, loosen builch_p xdth a clean, soti (loth _dier soaking. Do not use a stiff
brush; you may roughen tile sudilce of the dispenser.
[] Rinse and reassemble dispenser, Place dispenser back on the agitator,