GE 2200 Owner's Manual page 14

Beforeyou call forservice...
(con) PERFORMANCE Possible Causes What To 0o
Pilling Result of normal wear on * \.\qlile dlis is not ( aused by I he washer you (;Ill sl()w llle
poly-cotton blends and pilling pro(ess by washing garments inside out.
fuzzy fabrics
Snags, holes, tears, rips Pins, snaps, hooks, sharp • Fasten snaps, hooks, buttons, and zippers.
or excessive wear buttons, belt buckles,
zippers, and sharp objects " Remox e loose items like pins, obje(ts ill po(kets
left in pockets and sharp barons.
" Turn knits (whi(h snag easily) inside out.
Undiluted chlorine bleach * Check bleach package instructions fi)r proper amount.
= Nexer add undiluted bleach to wash or allow ( lothes
to come ill (:onta(t with undthlt ed blea(h.
Chemicals llke hair bleach * Rinse items that may haxe chemicals on diem before
or dye, permanent wave washing.
solution
Wrinkling Improper sorting * Avoid mi_ug hea_ T items (like work (lodles) whh
light items (like blouses).
• TI y a fhbri( sotlener.
Overloading or = Load your washer st) (:It)tiles ha'_e enough roocn
incorrect water level to move fleely.
Incorrect wash and * Match Cy(le sele(uon to tile type of_i_bri( you are
dry cycles washing (espe(ially for easy (are loads).
Repeated washing in " Wash ill warm or cold water.
water that is too hot
NOISE Possible Causes What To Be
Washer is noisy Washer is uneven * To level tlle fiom of tile _asher, adjust tile flont leveling
legs by rotating the indMdual leg ill tile proper direction
tbr up or down. To level ba(:k of washer, litl ba(:k of
me(blue 4" and set down.
Washer load is " Push tile Cy(le knob ill to stop tile washer, open tlle lid
unbalanced aud redistribme die load ex enly. Close tile lid aud restan.
Shipping rod is still assembled * To rerno., e shipping rod flom washer, pull yellow tag and
in unit attached rod fiom d_e bottom right hand side of washer.
) ,,,,.
Washer is sitting too close * Iull washer away fl()m tile wall; about 4 is needed.
to wall (causes knocking
during cycle)
OTHER Possible Causes What To 0o
I.abels on the exterior Occasionallythe adhesive * Use a hair (hyer set at tile lowest heat setting, direcrng
of the washer will not used on the labels does tile air at tile label fi)r a short amount of time. This _x411
peel off cleanly not release clearly release tile adhesix e easily, wid_om damaging die surthce
()f the wa slier.
/4