Table of Contents
Advertisement
On indicator lights
Your range is equipped with one or more element on
indicator lights located on the control panel just above the
surface control knobs (See Fig. 1). The element on
indicator light will glow when a surface element is turned
ON. A quick glance at this indicator light after cooking is an
easy check to be sure ALL surface controls are turned OFF.
2
OFF
on indicator
light
I
OFF
_"_ d
Home Canning
Be sure to read and observe all the following points when
home canning with your appliance. Check with the USDA
(United States Department of Agriculture) website and be
sure to read all the information they have available as well
as follow their recommendations for home canning
procedures.
Use only quality flat bottom canners when home canning.
Use a straight-edge to check canner bottom (see
"Cookware material types" in the Before setting
surface controls section).
• Use only a completely flat bottom canner with no
ridges that radiate from the bottom center when home
canning using a ceramic cooktop.
Make sure the diameter
of the canner does not
exceed :Linch beyond the surface element
markings or burner, It is recommended to use smaller
diameter canners on electric coil and ceramic glass
cooktops.
• Start with hot tap water to bring water to boil more
quickly.
• Use the highest heat seating when first bringing the water
to a boil. Once boiling is achieved, reduce heat to lowest
possible setting to maintain that boil.
NEVER place or straddle a cooking utensil over 2 different
surface cooking elements at the same time. This can
cause uneven heating results. For models equipped with
a ceramic cooktop, the cooktop could fracture.
Advertisement
Table of Contents
