Advertisement
This function enables you to set a recording
length simply by pressing the REC/OTR
button
on the TV/VCR.
Make sure:
• TV/VCR power must be turned on.
• Insert a cassette tape with its erase
prevention
tab in place
(If necessary,
rewind
or fast forward the tape to the point you want
to begin _ecording.)
NOTE:
• This function
CANNOT be done front the
remote control
• Recording
starts immediately
when the
REC/OTR
button is pressed.
• When the REC/OTR
button is pressed 18
times, the TV/VCR returns to the Normal
Recording
mode.
• To stop the OTR operation,
press the STOP
button on the TV/VCR or on the remote
controi.
• To show the rema+ning time, press the
DISPLAY
button on the remote control so that
"OTR" appears on the TV screen. (It will show
up momentarily
then disappear.)
• Recording
stops when 0:00 is reached,
• Please note that in the SLP mode. maximum
recording time, is 8 hours using a T-160 or 6
hours using T-120 tape.
• If the tape runs out before the end time, the
TV/VCR will switch to the Stop mode
immediately,
ejects the tape and turns itself off.
Press the number buttons on the remote control
or the CHANNEL
UP or DOWN button.
Remember:
If the TV/VCR is connected
to a
cable box or satellite box, the TV/VCR must be
on CH3 or CH4, then the channel to be recorded
is selected on the cable box or satellite box,
Press the SPEED button to select the desired
tape speed (SP/SLP).
Press the REC/OTR
button
once to begin recording.
i
I
_,F+
......
J
Press twice to set recording
length to 30 minutes.
Each additional
push of the button will increase
the recording
time by 30 minutes, up to a total of
480 minutes.
Push(es)
Display
Recording
length
1 push
(Begin Recording)
2 pushes
0:30
30 minutes
3 pushes
1:00
60 minutes
17 pushe<
_:00
480 minutes
Unauthorized
recordings
of copyrighted
video tapes may be an
infringement
of copyright
laws.
Connect your _[V,'VCR and a Source (Playing) VCR
using tile following diagram.
[The TV/VCR]
'
[Ex: Source (P_aying) VCR
or camcorder]
Audio/Video
" "
adapter cable
_ o_T ,,
(not supplied)
-_=_
_:_,'
A_Jm_
1) Insert a pre-recorded
video cassette into the
Source (Playing)
VCR or camcorder.
2) Insert a blank video cassette, or one you want
to record over, into the TV/VCR's
cassette
compartment.
3) Press the SPEED button on remote control for
the TVNCR to select the desired recording
speed (SP/SLP).
4) Press the CHANNEL
UP or DOWN button on
the TV/VCR until "AUX" appears on the
screen.
5) Press the REC button on the TV/VCR
6) Begin playback
of the tape in the source
(Playing) VCR or camcorder.
NOTE: For best results during copying, use the
TV/VCR's
front panel controls whenever
possible. The remote control might affect the
source (Playing) VCR's playback
operation,
- 26 -
EN
9F06
Advertisement
