Mac Os X - Epson EMP 7900 Network Manual

The following table lists the components required for network printing.
Printing method
LPR printing
5. If the necessary components are not in the list, click Install to install them.
6. For LPR printing:
Double-click Internet Protocol (TCP/IP) on the Local Area Connection
Properties dialog box to open the Internet Protocols (TCP/IP) Properties
dialog box. Set the IP address, the subnet mask, etc. and then click OK.
7. Restart the computer.
The necessary components are now installed. Go to the section "Connecting
the Network Interface to the Network" on page 16.

Mac OS X

To assign an IP address, subnet mask, etc. to your Macintosh, follow the
steps below.
1. From the Apple menu, select System Preferences.
2. Open the Network control panel. Click the TCP/IP tab.
Note:
For Mac OS X 10.5, select Ethernet as the connecting method on the Network
control panel, select the method to assign the IP address from the Configure
menu, and then assign the IP address.
3. Select Built-in Ethernet from the Show pull down menu.
4. Assign an IP address and other settings if necessary.
5. Click the Apply Now button to save any changes.
Go to the section "Connecting the Network Interface to the Network" on
page 16.
Necessary components
Internet Protocol (TCP/IP)
Setting Up Your System for Network Printing
15