RTC battery
NOTE:
Removing the RTC battery and leaving it uninstalled for 5 or more minutes causes all
passwords and CMOS settings to be cleared.
Description
RTC battery
Before removing the RTC battery, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the memory module/WLAN module compartment cover (see
on page
Remove the RTC battery:
1.
Disconnect the RTC battery cable (1) from the system board.
2.
Remove the RTC battery (2) from the clip built into the base enclosure.
Reverse this procedure to install the RTC battery.
Battery on page
52).
44).
Component replacement procedures
Spare part number
450478-001
Primary memory module
57