Helpful Hints; Tools Required; Before You Start - Cub Cadet Ex SERIES Installation & Owner's Manual

NOTICE
Cabs, blades, and general accessories add
additional weight to the base vehicle.
Deduct the accessory's total weight from
the vehicle's rated capacity including
driver and passenger.
Exposure to Carbon Monoxide
can Cause illness, serious injury
or death. Never operate vehicle if
suspicious of Carbon Monoxide. Inspect exhaust
system for leaks monthly. Leaks can result from
loose connections, corrosion, cracks or other dam-
age to the exhaust manifold. If leaks are found,
repair or replace exhaust system. Do not use vehicle
until repair or replacement is complete.
CAB INSTALLATION

BEFORE YOU START

HELPFUL HINTS:

A. Refer to parts diagram toward the back of this manual
to help identify parts during the assembly process.
B. To assist with the cab installation, leave all bolts
loose for later adjustment unless otherwise specified.
C. Read and understand all instructions before beginning.
D. Plastic washers have been supplied to provide a
weather seal under the heads of all exterior bolts.
The plastic washer should be installed under each
bolt head directly against the outside cab surface.
Care should be taken not to over tighten the fast-
eners and damage the plastic washer. Also use
steel washers as required. See diagram.
E. Apply a clear silicone sealant to seal any minor
gaps that may occur due to vehicle variations.
F. Use caution to avoid damaging the factory installed
threaded inserts. Begin the bolt engagement by hand
to guard against potential cross threading.

TOOLS REQUIRED:

Set of standard and metric sockets
Set of standard and metric open end wrenches
Scissors
Plastic Washer
Cab Surface
One Phillips Head Screwdriver
One 3/8" Drive Ratchet
One 3/16" Allen Wrench (preferably "T" handle type)
Rev. -, p. 2 of 15
Fastener
Steel Washer