Advertisement
NOTICE
Cabs, blades, and general accessories add
additional weight to the base vehicle.
Deduct the accessory's total weight from
the vehicle's rated capacity including
driver and passenger.
Exposure to Carbon Monoxide can
Cause illness, serious injury or death.
Never operate vehicle if suspicious of Carbon Monoxide. Inspect
exhaust system for leaks monthly. Leaks can result from loose
connections, corrosion, cracks or other damage to the exhaust
manifold. If leaks are found, repair or replace exhaust system.
Do not use vehicle until repair or replacement is complete.
CAB INSTALLATION
BEFORE YOU START
HELPFUL HINTS:
A. Refer to parts diagram toward the back of this manual
to help identify parts during the assembly process.
B. To assist with the cab installation, leave all bolts
loose for later adjustment unless otherwise specified.
C. Read and understand all instructions before beginning.
D. Plastic washers have been supplied to provide a
weather seal under the heads of all exterior bolts.
The plastic washer should be installed under each
bolt head directly against the outside cab surface.
Care should be taken not to over tighten the fast-
eners and damage the plastic washer. Also use
steel washers as required. See diagram.
E. Apply a clear silicone sealant to seal any minor
gaps that may occur due to vehicle variations.
F. Use caution to avoid damaging the factory installed
threaded inserts. Begin the bolt engagement by hand
to guard against potential cross threading.
TOOLS REQUIRED:
Set of standard and metric sockets
Set of standard and metric open end wrenches
Scissors
Plastic Washer
Cab Surface
One Phillips Head and one Flat Screwdriver
One 3/8" Drive Ratchet
One 3/16" Allen Wrench (preferably "T" handle type)
One 5mm Allen Wrench (preferably "T" handle type)
Pliers
Rev. -, p. 2 of 19
Fastener
Steel Washer
Advertisement
