Side Frames - Cub Cadet Ex SERIES Installation & Owner's Manual

2. ROLL BAR BRACKETS (cont'd.)
2.2 Per figures 2.2 and 2.2.1, loosely assemble the roll
bar bracket and the roll bar mount around the ROPS tub-
ing as shown (with the slots outboard and the vibration
mount against the front facing surface of the ROPS tub-
ing). Use the following hardware: two 5/16-18 x 1" long
button head bolts, four steel washers, and two locknuts.
Locknuts to be towards the front of the tractor. Leave
bolts loose. Repeat for right side of tractor.
3.

SIDE FRAMES

3.1 Temporarily remove the doors from the side
frames for ease of handling. Open the door and lift up
and off the pin hinges on the side frames.
3.2 Per fig. 3.2, place a 1/4" thick rubber washer on
the fender of the tractor over the hole that has a factory
installed metric weldnut. Have the following hardware
ready: one M8 x 1.25 x 20mm long hex head bolt and
one standard 5/16" flat steel washer. For the front floor-
board, have the following hardware ready: one 5/16-18 x
1" long button head bolt, two steel washers, and one
locknut. Leave bolts loose.
1/4" thick rubber washer
Fig. 3.2 (view from right rear side of tractor)
roll bar
mount
Fig. 2.2 (view from left rear side of tractor)
center lock-
nut shown
(vibration
mount on
other side)
ref.: seat
Fig. 2.2.1 (view from left rear side of tractor)
Rev. -, p. 4 of 15
roll bar
bracket
slots on roll
bar mount to
be outboard