Advertisement
18. FINISHING TOUCHES (cont'd.)
18.4 If a soft rear curtain has been installed, install the fol-
lowing hardware into the factory installed threaded inserts in
the back of each of the side frames: four 5/16-18 x 3/4" long
button head bolts, four plastic washers, and four steel wash-
ers. See fig. 18.4. These will serve as weather plugs when an
optional hard rear panel is not installed.
18.5 If an optional hard rear panel has been installed, apply
PSA hook velcro to the lower inside surface and attach the
loose rear edge of the underseat filler. Work the velcroed
flaps around the seatbelts to suit. See fig. 18.5.
18.6 Re-install the SMV sign using the original equipment
hardware. See fig. 18.6.
18.7 Peel protective film from windows.
18.8 Note: extra hardware has been provided in case they
get lost. Discard extras such as washers, etc.
18.9 Install the front windshield wiper per the installation
instructions included with the wiper kit.
18.10 Additional optional equipment available: Work
Lights, Heater, Hard Rear Panel, Sliding Door Windows, and
Rear Window
19.
CARE AND MAINTENANCE
19.1
Check and tighten hardware after 40 hours of opera-
tion. Periodically inspect and tighten hardware for the re-
mainder of the unit's life.
19.2
Wash the painted surfaces of the unit with commer-
cial automotive cleaning products.
19.3
Clean windows with glass cleaner.
19.4
Vinyl components should be washed with a mild so-
lution of warm soapy water.
19.5
Clear vinyl can be easily scratched. Be careful clean-
ing frost or snow from rear curtain. Do not roll curtain in
cold weather. The curtain becomes stiff and may crack. Keep
curtain clean.
Fig. 18.4 (view from right rear side of tractor)
filler velcros
onto itself
around seatbelts
Fig. 18.5 (view from right side of tractor)
Fig. 18.6 (view from inside the cab)
Rev. -, p. 17 of 19
fill thread-
ed inserts
these 2 bolts
Advertisement
