Drying Sequence - Zanussi TCS 674 E Installation And Instruction Manual

i

Drying sequence

Before starting up for the first time it is advisable
lo load a few moist cloths into the dryer and to let
it run for about 20 minutes. This ensures that no
dust and dirt is left in the drum.
1. Load the laundry
Open the door by depressing button
Load the items one at a time, shaking them out
loosely and close the door.
2 Select drying programme or time
Turn the programme selector dial to the
programme letter or time, the mains-on light
illuminates.
3 Select the required option
Depress "low temperature" button
to dry synthetics with a time controlled
programme and/or "buzzer off" button
desired.
4 Start the programme
Depress START-button
begins and the control light
Important: If you wish to change the programme
during operation, turn the selector dial to "0",
select the new programme and depress START-
button again.
5 When drying is completed
Before the end of the cycle, an automatic cooling
phase of 9 mins. is carried out to cool the
laundry: the control light
this phase lights and
alternatively.
If you do not remove the laundry at the end of the
programme, the machine will perform the anti-
crease phase which lasts 30 mins. max.
If you have not depressed button
will sound every 10 seconds, the lights
will flash alternatively. To remove
the laundry at this stage, turn the selector dial to
"0", the mains-on light goes out.
If you do not remove the laundry during the anti-
crease phase, the appliance will stop
automatically at the end of this phase: the mains-
on light will remain lighted and the control lights
and will continue to flash.
Clean the filter and empty water container.
10
.
if you have
if
: the drying programme
goes on.
is on. At the end of
will begin to flash
, the buzzer
and
P0449
P0918